Ipv6 Pim Spt-Threshold - Allied Telesis x510-28GTX Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM SPT THRESHOLD

ipv6 pim spt-threshold

Overview This command turns on the ability for the last-hop PIM-SMv6 router to switch to
SPT (shortest-path tree).
The no variant of this command turns off the ability for the last-hop PIM-SMv6
router to switch to SPT.
NOTE
not at all; it is not rate-based.
ipv6 pim spt-threshold
Syntax
no ipv6 pim spt-threshold
Mode Global Configuration
Examples To enable the last-hop PIM-SMv6 router to switch to SPT, use the following
commands:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
To stop the last-hop PIM-SMv6 router from being able to switch to SPT, use the
following commands:
awplus#
awplus(config)#
Related ipv6 pim spt-threshold group-list
Commands
C613-50170-01 Rev B
: The switching to SPT happens either at the receiving of the first data packet, or
configure terminal
ipv6 forwarding
ipv6 multicast-routing
ipv6 pim spt-threshold
configure terminal
no ipv6 pim spt-threshold
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
1409