Ipv6 Mld Static-Group - Allied Telesis x510-28GTX Command Reference Manual

MLD MLD S C
AND NOOPING OMMANDS
6 -
IPV MLD STATIC GROUP

ipv6 mld static-group

Overview Use this command to statically configure IPv6 group membership entries on an
interface. To statically add only a group membership, do not specify any
parameters.
Use the no variant of this command to delete static group membership entries.
Syntax ipv6 mld static-group <ipv6-group-address> [source
<ipv6-source-address>|ssm-map] [interface <port>]
no ipv6 mld static-group <ipv6-group-address> [source
<ipv6-source-address>|ssm-map] [interface <port>]
Mode Interface Configuration for a VLAN interface.
Usage This command applies to MLD Snooping on a VLAN interface to statically add
groups and/or source records.
Examples To add a static group record, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To add a static group and source record, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
fe80::2fd:6cff:fe1c:b
C613-50170-01 Rev B
Parameter
<ipv6-group-
address>
<ipv6-source-
address>
ssm-map
<port>
configure terminal
interface vlan2
configure terminal
interface vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Specify a standard IPv6 Multicast group address to be
configured as a static group member.
The IPv6 address uses the format X:X::X:X.
Optional. Specify a standard IPv6 source address to be
configured as a static source from where multicast
packets originate.
The IPv6 address uses the format X:X::X:X.
Mode of defining SSM mapping. SSM mapping statically
assigns sources to MLDv1 groups to translate these (*,G)
groups' memberships to (S,G) memberships for use with
PIM-SSM.
Optional. Physical interface. This parameter specifies a
physical port. If this parameter is used, the static
configuration is applied to just to that physical interface.
If this parameter is not used, the static configuration is
applied on all ports in the VLAN.
ipv6 mld static-group ff1e::10
ipv6 mld static-group ff1e::10 source
1276