Stack Management Vlan - Allied Telesis x510-28GTX Command Reference Manual

V C S (VCS
IRTUAL HASSIS TACKING

STACK MANAGEMENT VLAN

stack management vlan
Overview Use this command to configure the stack management VLAN ID.
Use the no variant of this command to change the stack management VLAN ID
back to the default (VLAN ID 4094).
Syntax stack management vlan <2-4094>
no stack management vlan
Default VLAN ID 4094
Mode Global Configuration
Usage The management VLAN is used for high speed communication between stacked
units. This command enables you to change the ID of this VLAN.
The default stacking management VLAN ID is 4094, which is the last configurable
VLAN ID in the switch.
The stack management VLAN is created and configured automatically so that the
stack VLAN cannot be used in the stack's VLAN configuration commands. This
means you cannot enter commands such as:
awplus(config-vlan)#
You should only change the management VLAN if the VLAN ID 4094 needs to be
used in the stack's VLAN configuration.
If necessary, you can use the no variant of this command to change the
management VLAN back to its default value.
Changes to the stacking management VLAN configuration will take effect once the
stack is restarted.
Examples To set the management VLAN to 4000, enter the following commands:
awplus#
awplus(config)#
To reset the management VLAN back to the default (4094), enter the following
commands:
awplus#
awplus(config)#
Related stack management subnet
Commands
C613-50170-01 Rev B
™) C
TACK OMMANDS
Parameter Description
<2-4094>
Stack management VLAN ID.
configure terminal
stack management vlan 4000
configure terminal
no stack management vlan
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
vlan <stack-management-VLAN-ID>
2092