Ipv6 Pim Neighbor-Filter - Allied Telesis x510-28GTX Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM NEIGHBOR FILTER

ipv6 pim neighbor-filter

Overview This command enables filtering of neighbors on the VLAN interface. When
configuring a neighbor filter, PIM-SMv6 will either not establish adjacency with the
neighbor, or terminate adjacency with the existing neighbors if denied by the
filtering IPv6 access list.
Use the no variant of this command to disable this function.
ipv6 pim neighbor-filter <IPv6-accesslist>
Syntax
no ipv6 pim neighbor-filter <IPv6-accesslist>
Default By default, there is no neighbor filtering applied to an interface.
Mode Interface Configuration for a VLAN interface.
awplus#
Example
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
fe80:20e:cff:fe01:facc
awplus(config-if)#
awplus(config-if)#
C613-50170-01 Rev B
Parameter Description
<IPv6-
Specify a Standard or an Extended software IPv6 access list name for
accesslist>
the PIM-SMv6 neighbor filter.
See the
for supported IPv6 ACLs.
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
ipv6 enable
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
IPv6 Software Access Control List (ACL) Commands
ipv6 pim neighbor-filter filter1
ipv6 access-list standard filter1 deny
ipv6 access-list standard filter1 permit any
exit
chapter
1396