Ipv6 Pim Exclude-Genid - Allied Telesis x510-28GTX Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM EXCLUDE GENID

ipv6 pim exclude-genid

Overview Use this command to exclude the GenID option from Hello packets sent out by the
PIM-SMv6 module on a particular interface. This command is used to inter-operate
with older Cisco IOS versions.
Use the no variant of this command to revert to default settings.
Syntax ipv6 pim exclude-genid
no ipv6 pim exclude-genid
Default By default, this command is disabled; the GenID option is included.
Mode Interface Configuration for a VLAN interface.
awplus#
Examples
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus#
awplus(config)#
awplus(config-if)#
C613-50170-01 Rev B
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
ipv6 enable
ipv6 pim exclude-genid
configure terminal
interface vlan2
no ipv6 pim exclude-genid
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
1390