Alternate-Checksum-Mode - Allied Telesis x510-28GTX Command Reference Manual

VRRP C
OMMANDS
- -
ALTERNATE CHECKSUM MODE

alternate-checksum-mode

Overview Use this command to enable an alternate checksum mode for VRRPv3 to allow
inter-operability with some other vendors' products. The IPv4 checksum for
VRRPv3 advertisements will then use a pseudo header in the calculation.
This mode may be required if the other product indicates checksum errors on VRRP
packets sent by AlliedWare Plus devices.
Use the no variant of this command to disable the alternate checksum mode.
alternate-checksum-mode
Syntax
no alternate-checksum-mode
Default Disabled
Mode Router Configuration
Example To turn on the alternate checksum mode for VRRP instance 1 on VLAN1, use the
commands:
awplus#
awplus(config)#
awplus(config-router)#
To turn off the alternate checksum mode for VRRP instance 1 on VLAN1, use the
commands:
awplus#
awplus(config)#
awplus(config-router)#
Related show running-config
Commands
Command Version 5.4.7-1.1: command added
changes
C613-50170-01 Rev B
configure terminal
router vrrp 1 vlan1
alternate-checksum-mode
configure terminal
router vrrp 1 vlan1
no alternate-checksum-mode
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
2111