Epsr - Allied Telesis x510-28GTX Command Reference Manual

E P S
THERNET ROTECTION WITCHED

EPSR

epsr
Overview This command sets the timer values for an EPSR instance. These are only valid for
master nodes.
NOTE
Syntax epsr <epsr-instance> {hellotime <1-32767>|failovertime
<2-65535> ringflaptime <0-65535>}
no epsr <epsr-instance>
CAUTION
instance.
Mode EPSR Configuration
To set the hellotimer to 5 seconds for the EPSR instance called blue, use the
Examples
command:
awplus(config-epsr)#
NOTE
seconds.
To delete the EPSR instance called "blue", use the command:
awplus(config-epsr)#
C613-50170-01 Rev B
R (EPSR ™) C
ING ING OMMANDS
: Running your switch as an EPSR master node requires a feature license.
: Using the "no" variant of this command will remove the specified EPSR
Parameter
<epsr-instance>
hellotime <1-32767>
failovertime <2-65535>
ringflaptime <0-65535>
: When stacking is used with EPSR, the EPSR failovertime should be at least 5
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Name of the EPSR instance.
The number of seconds between the transmission of
health check messages.
The number of seconds that a master waits for a
returning health check message before entering the
failed state. The failover time should be greater
than twice the hellotime. This is to force the master
node to wait until it detects the absence of two
sequential healthcheck messages before entering
the failed state.
The minimum number of seconds that a master must
remain in the failed state.
epsr blue hellotime 5
2151