G8032 Manual-Switch Erp-Instance - Allied Telesis x510-28GTX Command Reference Manual

G.8032 E R P
THERNET ING ROTECTION
8032 - -
G MANUAL SWITCH ERP INSTANCE

g8032 manual-switch erp-instance

Overview Use this command to manually cause a protection switch on a G.8032 Ethernet
Ring Protection (ERP) instance ring port.
g8032 manual-switch erp-instance <erp-instance-name>
Syntax
{east-interface|west-interface|terminating-interface}
Mode Privileged Exec
Usage G.8032 supports a Manual Protection Switch action initiated by the operator. A
Manual Protection Switch command is to be issued at a given G.8032 node and
given port in the ring. This results in a block being applied at that ring port (and an
unblock on the opposite ring port), and a R-APS designated Manual Switch
message to flow around the ring causing the RPL to become unblocked.
The difference between a Manual switch and a Forced switch is that the Manual
Switch will be ignored under various conditions. In particular, only one Manual
Switch is allowed on a G.8032 ring at a time.
If the G.8032 Physical Ring instance associated with the specified ERP instance is
set to terminating-interface, then only one ring port is available and
terminating-interface must be used in this command, otherwise specify the
east-interface or the west-interface.
To clear this action command, use the
Example To issue a Manual Protection Switch on the East interface of an ERP instance named
"blue", use the following command:
awplus#
Related clear g8032 erp-instance
Commands
g8032 erp-instance
Command Version 5.4.7-0.1: command added
changes
C613-50170-01 Rev B
S C
WITCHING OMMANDS
Parameter
<erp-instance-name>
east-interface
west-interface
terminating-interface The G.8032 ERP instance's Terminating ring port
g8032 manual-switch erp-instance blue east-interface
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
The name of the G.8032 ERP instance
The G.8032 ERP instance's East ring port
The G.8032 ERP instance's West ring port
clear g8032 erp-instance command.
2189