Ipv6 Mld Query-Interval - Allied Telesis x510-28GTX Command Reference Manual

MLD MLD S C
AND NOOPING OMMANDS
6 -
IPV MLD QUERY INTERVAL

ipv6 mld query-interval

Overview Use this command to configure the frequency of sending MLD host query
messages.
Use the no variant of this command to return to the default frequency.
Syntax ipv6 mld query-interval <seconds>
no ipv6 mld query-interval
Default The default query interval is 125 seconds.
Mode Interface Configuration for a specified VLAN interface or a range of VLAN
interfaces.
Usage This command applies to interfaces configured for MLD Layer-3 multicast
protocols.
Example The following example changes the frequency of sending MLD host-query
messages to 2 minutes:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 mld querier-timeout
Commands
C613-50170-01 Rev B
Parameter Description
<seconds>
Variable that specifies the time delay between successive MLD host
query messages (in seconds). Valid values are from 1 to 18000
seconds.
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ipv6 enable
ipv6 mld query-interval 120
1263