Data-Traffic - Allied Telesis x510-28GTX Command Reference Manual

G.8032 E R P
THERNET ING ROTECTION
-
DATA TRAFFIC

data-traffic

Overview Use this command to add a data traffic VLAN or a range of VLANs to be protected
by this G.8032 Ethernet Ring Protection (ERP) instance.
Use the no variant of this command to remove a data traffic VLAN or a range of
VLANs.
Syntax data-traffic <vid-list>
no data-traffic <vid-list>
Mode G8032 Configure Switch
Usage •
•
•
•
•
•
•
Example To add a data traffic VLAN with a VLAN ID of "103" to an ERP instance named "blue",
use the following commands:
awplus(config)#
awplus(g8032-config-switch)#
Related g8032 erp-instance
Commands
show g8032 erp-instance
Command Version 5.4.7-0.1: command added
changes
C613-50170-01 Rev B
S C
WITCHING OMMANDS
Parameter Description
<vid-list>
The data traffic VLAN ID(s). This can be a single VLAN ID, or can be
a range of VLAN IDs separated by hyphen, or a comma separated
list of VLAN IDs and ranges. Each VLAN ID can take on the range of
1 to 4094
A G.8032 ERP instance can protect 0, 1 or more VLANs carrying data traffic.
This ERP instance must be associated with a physical ring instance.
Other ERP instances using the same physical ring instance are not allowed to
have the same data traffic VLAN(s) as this ERP instance.
The data VLAN(s) must already exist.
The data VLAN(s)' port members should be members of the ring interface(s),
but it is not enforced.
When a data traffic VLAN(s) is removed, any blocks that were in place on the
ring ports for this VLAN(s) are removed. The user should make sure when
removing the VLAN(s) from the ERP instance that a loop is not formed.
Data traffic VLAN(s) can be added or removed while the ERP instance is
enabled or disabled.
g8032 erp-instance blue
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
data-traffic 103
2181