Enable (Vrrp) - Allied Telesis x510-28GTX Command Reference Manual

VRRP C
OMMANDS
(VRRP)
ENABLE

enable (VRRP)

Overview Use this command to enable the VRRP session on the router to make it participate
in virtual routing. To make changes to the VRRP configuration, first disable the
router from participating in virtual routing using the
enable
Syntax
Mode Router Configuration
Usage You must configure the virtual IP address and define the interface for the VRRP
session (using the
ipv6 vrrp (interface)
See the
about VRRPv3 IPv4 and IPv6 configuration details.
Examples To enable the VRRP session for VRRP VR ID 5 on vlan2, use the commands:
awplus#
awplus(config)#
awplus(config-router)#
To enable the VRRPv3 session for VRRPv3 VR ID 3 on vlan1, use the commands:
awplus#
awplus(config)#
awplus(config-router)#
Related disable (VRRP)
Commands
router vrrp (interface)
router ipv6 vrrp (interface)
show vrrp
virtual-ip
virtual-ipv6
C613-50170-01 Rev B
virtual-ip or
commands) before using this command.
VRRP Feature Overview and Configuration Guide
configure terminal
router vrrp 5 vlan2
configure terminal
router ipv6 vrrp 3 vlan1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
virtual-ipv6 and the router vrrp (interface)
enable
enable
disable (VRRP) command.
or router
for more information
2118