Atmf Controller - Allied Telesis x510-28GTX Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

ATMF CONTROLLER

atmf controller
Overview Use this command to configure the device as an AMF controller. This enables you
to split a large AMF network into multiple areas.
AMF controller is a licensed feature. The number of areas supported on a controller
depends on the license installed on that controller.
Use the no variant of this command to remove the AMF controller functionality.
atmf controller
Syntax
no atmf controller
Mode Global configuration
Usage If a valid AMF controller license is not available on the device, the device will accept
this command but will not act as a controller until you install a valid license. The
following message will warn you of this:
"An AMF Controller license must be installed before this feature will become
active"
NOTE
controller command then the device must be rebooted if it is to function properly as
an AMF master.
Example To configure the node named controller-1 as an AMF controller, use the
commands:
controller-1#
controller-1(config)#
To stop the node named controller-1 from being an AMF controller, use the
commands:
controller-1#
controller-1(config)#
Related atmf area
Commands
show atmf
C613-50170-01 Rev B
™ (AMF) C
RAMEWORK OMMANDS
: If the AMF controller functionality is removed from a device using the no atmf
configure terminal
configure terminal
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
atmf controller
no atmf controller
2255