Aaa Authorization Config-Commands - Allied Telesis x510-28GTX Command Reference Manual

TACACS+ C
OMMANDS
-
AAA AUTHORIZATION CONFIG COMMANDS

aaa authorization config-commands

Overview Use this command to enable command authorization on configuration mode
commands. By default, command authorization applies to commands in exec
mode only.
Use the no variant of this command to disable command authorization on
configuration mode commands.
aaa authorization config-commands
Syntax
no aaa authorization config-commands
Default By default, command authorization is disabled on configuration mode commands.
Mode Global Configuration
Usage If authorization of configuration mode commands is not enabled then all
configuration commands are accepted by default, including command
authorization commands.
NOTE
command authorization configuration as it prevents the feature from being disabled
to gain access to unauthorized exec mode commands.
Example To enable command authorization for configuration mode commands, use the
commands:
awplus#
awplus(config)#
To disable command authorization for configuration mode commands, use the
commands:
awplus#
awplus(config)#
Related aaa authorization commands
Commands
authorization commands
tacacs-server host
Command Version 5.4.6-2.1: command added
changes
C613-50170-01 Rev B
: Authorization of configuration commands is required for a secure TACACS+
configure terminal
aaa authorization config-commands
configure terminal
no aaa authorization config-commands
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
1981