Ipv6 Traffic-Filter - Allied Telesis x510-28GTX Command Reference Manual

IP 6 H A C
V ARDWARE CCESS ONTROL
6 -
IPV TRAFFIC FILTER

ipv6 traffic-filter

Overview This command adds an IPv6 hardware-based access-list to an interface. The
number of access-lists that can be added is determined by the amount of available
space in the hardware-based packet classification tables.
Use the no variant of this command to remove an IPv6 hardware-based access-list
from an interface.
ipv6 traffic-filter <ipv6-access-list-name>
Syntax
no ipv6 traffic-filter <ipv6-access-list-name>
Mode Interface Configuration (to apply an IPv6 hardware ACL to a specific switch port).
Usage This command adds an IPv6 hardware-based access-list to an interface. The
number of access-lists that can be added is determined by the amount of available
space in the hardware-based packet classification tables.
To apply the access-list to all ports on the switch, execute the command in the
Global Configuration mode. To apply the access-list to a Layer 2 interface or Layer
2 interface range, apply the command in the Interface Configuration mode. See
the examples for each mode below.
Examples To add access-list "acl1" as a traffic-filter to interface port1.0.1, enter the
commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove access-list "acl1" as a traffic-filter from interface port1.0.1, enter the
commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ipv6 access-list (named IPv6 hardware ACL)
Commands
(named IPv6 hardware ACL: ICMP entry)
C613-50170-01 Rev B
L (ACL) C
IST OMMANDS
Parameter
<ipv6-access-list-name>
configure terminal
interface port1.0.1
configure terminal
interface port1.0.1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Hardware IPv6 access-list name.
ipv6 traffic-filter acl1
no ipv6 traffic-filter acl1
1584