Clear G8032 Erp-Instance - Allied Telesis x510-28GTX Command Reference Manual

Stackable gigabit edge switches x510 series

Table of Contents

clear g8032 erp-instance

Use this command to:

clear g8032 erp-instance <erp-instance-name>

Privileged Exec

This command can be used after a protection switch has occurred and the failure

has cleared. If reversion is enabled, this command will trigger a reversion

immediately, without having to wait for certain timers to expire (such as WTB or

WTR). If reversion has been disabled, this command will trigger a reversion.

Alternatively, this command can be used on an ERP instance where a forced-switch

or manual-switch command has been successfully entered to clear that action. The

command will be ignored if a force-switch or manual-switch command had not

been previously entered successfully, even if such node is in the FORCED_SWITCH

or MANUAL_SWITCH state.

To trigger a reversion immediately without waiting for a timer to expire on an ERP

instance named "blue", use the following command:

Alternatively, to clear a previously applied forced-switch from an ERP instance

named "blue", use the following command:

The forced-switch would be created using a command like this one, which forces a

protection switch on the East interface of an ERP instance named "blue":

g8032 erp-instance

g8032 forced-switch erp-instance

g8032 manual-switch erp-instance

Version 5.4.7-0.1: command added

C613-50170-01 Rev B

trigger a reversion immediately, without waiting for timers to expire, or

clear a forced-switch or manual-switch command that was previously

successfully entered on a G.8032 Ethernet Ring Protection (ERP) instance.

<erp-instance-name>

clear g8032 erp-instance blue

g8032 forced-switch erp-instance blue east-interface

Command Reference for x510 Series

AlliedWare Plus™ Operating System - Version 5.4.7-1.x

The name of the G.8032 ERP instance

Show Quick Links

Table of Contents