Ipv6 Mld Query-Max-Response-Time - Allied Telesis x510-28GTX Command Reference Manual

MLD MLD S C
AND NOOPING OMMANDS
6 - -
IPV MLD QUERY MAX RESPONSE

ipv6 mld query-max-response-time

Overview Use this command to configure the maximum response time advertised in MLD
queries.
Use the no variant of with this command to restore the default.
Syntax ipv6 mld query-max-response-time <seconds>
no ipv6 mld query-max-response-time
Default 10 seconds
Mode Interface Configuration for a specified VLAN interface or a range of VLAN
interfaces.
Usage This command applies to interfaces configured for MLD Layer-3 multicast
protocols.
Example The following example configures a maximum response time of 8 seconds:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
C613-50170-01 Rev B
-
TIME
Parameter Description
<seconds>
Maximum response time (in seconds) advertised in MLD queries.
Valid values are from 1 to 240 seconds.
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ipv6 enable
ipv6 mld query-max-response-time 8
1264