(Named Hardware Acl: Mac Entry) - Allied Telesis x510-28GTX Command Reference Manual

IP 4 H A C
V ARDWARE CCESS ONTROL
( ACL: MAC
NAMED HARDWARE

(named hardware ACL: MAC entry)

Overview Use this command to add a MAC address filter entry to the current hardware
access-list. The access-list will match on packets that have the specified source and
destination MAC addresses. You can use the value any instead of source or
destination MAC address if an address does not matter.
If you specify a sequence number, the switch inserts the new filter at the specified
location. Otherwise, the switch adds the new filter to the end of the access-list.
The no variant of this command removes a filter entry from the current hardware
access-list. You can specify the filter entry for removal by entering either its
sequence number (e.g. no 100), or by entering its filter profile without specifying
its sequence number (e.g. no permit mac aaaa.bbbb.cccc 0000.0000.0000 any).
You can find the sequence number by running the
ACLs)
Hardware ACLs will permit access unless explicitly denied by an ACL action.
[<sequence-number>] <action> mac {<source-mac>|any}
Syntax
{<dest-mac>|any} [vlan <1-4094>] [inner-vlan <1-4094>]
no <sequence-number>
no <action> mac {<source-mac>|any} {<dest-mac>|any} [vlan
<1-4094>] [inner-vlan <1-4094>]
C613-50170-01 Rev B
L (ACL) C
IST OMMANDS
)
ENTRY
command.
Parameter Description
<4000-4699>
Hardware MAC access-list.
<action>
The action that the switch will take on matching packets:
deny
permit
copy-to-cpu
copy-to-mirror
send-to-mirror
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
show access-list (IPv4 Hardware
Reject packets that match the source
and destination filtering specified with
this command.
Permit packets that match the source
and destination filtering specified with
this command.
Send a copy of matching packets to
the CPU.
Send a copy of matching packets to
the mirror port.
Use the mirror interface command to
configure the mirror port.
Send matching packets to the mirror
port.
Use the mirror interface command to
configure the mirror port.
1503