Show Auth Sessionstatistics - Allied Telesis x510-28GTX Command Reference Manual

A C
UTHENTICATION OMMANDS

SHOW AUTH SESSIONSTATISTICS

show auth sessionstatistics
Overview This command shows authentication session statistics for the specified interface,
which may be a static channel (or static aggregator) or a dynamic (or LACP)
channel group or a switch port.
show auth sessionstatistics [interface <interface-list>]
Syntax
Mode Privileged Exec
To display authentication statistics for port1.0.6, enter the command:
Example
awplus#
Output Figure 42-3: Example output from the show auth sessionstatistics command
C613-50170-01 Rev B
Parameter
interface
<interface-list>
show auth sessionstatistics interface port1.0.6
Authentication session
statistics for interface port1.0.6
session user name: manager
session authentication method: Remote server
session time: 19440 secs
session terminat cause: Not terminated yet
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Specify ports to show.
The interfaces or ports to configure. An interface-list can be:
• an interface (e.g. vlan2), a switch port (e.g.
port1.0.6), a static channel group (e.g. sa2) or a
dynamic (LACP) channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by
a hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or
sa1-2, or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix
interface types in a list
The specified interfaces must exist.
1817