Ipv6 Pim Hello-Interval - Allied Telesis x510-28GTX Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM HELLO INTERVAL

ipv6 pim hello-interval

Overview This command configures a hello-interval value for PIM-SMv6.
Use the no variant of this command to reset the hello-interval for PIM-SMv6 to the
default.
Syntax ipv6 pim hello-interval <interval>
no ipv6 pim hello-interval
Default The default hello-interval value is 30 seconds. The default is restored using the
negated form of this command.
Mode Interface Configuration for a VLAN interface.
Usage When the hello interval is configured, and the hello holdtime is not configured, or
when the configured hello-holdtime value is less than the new hello-interval value;
the holdtime value is modified to the (3.5 * hello interval). Otherwise, the
hello-holdtime value is the configured value.
awplus#
Example
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
C613-50170-01 Rev B
Parameter Description
<interval>
<1-65535> The value in seconds (no fractional seconds accepted).
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ipv6 enable
ipv6 pim hello-interval 123
1393