Ipv6 Pim Ssm - Allied Telesis x510-28GTX Command Reference Manual

PIM-SM 6 C
V OMMANDS
6
IPV PIM SSM

ipv6 pim ssm

Overview Use this command to define the Source Specific Multicast (SSM) range of IPv6
multicast addresses. PIM-SMv6 routers will only install (S,G) entries for multicast
groups (addresses) residing in the SSM range.
Use the no variant of this command to disable the SSM range.
Syntax ipv6 pim ssm [default|range <named-access-list>]
no ipv6 pim ssm
Default By default, the command is disabled.
Mode Global Configuration
Usage Any (*,G) or (S,G,rpt) joins received for multicast groups (addresses) within the
range, are not installed in PIM-SMv6 mroute table.
Examples The following example shows how to configure SSM service for the IPv6 address
range defined by IPv6 access list IPv6-PIM-SSM-RANGE:
awplus#
awplus(config)#
permit ff3e::/32
awplus(config)#
The following commands show how to set PIM-SSM as default:
awplus#
awplus(config)#
The following commands show how to disable PIM-SSM:
awplus#
awplus(config)#
C613-50170-01 Rev B
Parameter
default
range
<named-access-list> Specify a named standard access list.
configure terminal
ipv6 access-list standard IPv6-PIM-SSM-RANGE
ipv6 pim ssm range IPv6-PIM-SSM-RANGE
configure terminal
ipv6 pim ssm default
configure terminal
no ipv6 pim ssm
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Named Standard Access List. Use FF3x::/32 group range
for SSM.
Specify an ACL for group range to be used for SSM.
1411