Openflow Version - Allied Telesis x510-28GTX Command Reference Manual

O F C
PEN LOW OMMANDS

OPENFLOW VERSION

openflow version
Overview Use this command to change the supported OpenFlow version numbers on the
switch. You can specify a list of version numbers.
Use the no variant of this command to change the version number of the
OpenFlow protocol back to the default version 1.3.
Syntax openflow version <version-list>
no openflow version
Default The OpenFlow version is set to 1.3 by default.
Mode Global Configuration
Usage This command overwrites any previously configured OpenFlow versions with the
default OpenFlow version 1.3.
Example To change the OpenFlow protocol version to 1.0 and 1.3:
awplus(config)#
To change the OpenFlow protocol version to the default 1.3:
awplus(config)#
Related show openflow config
Commands
C613-50170-01 Rev B
Parameter
<version-list>
openflow version 1.0 1.3
no openflow version
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Specifies a list of version numbers separated by a space. The
version numbers are 1.0 and 1.3.
2048