Trust Dscp - Allied Telesis x510-28GTX Command Reference Manual

Q S C
O OMMANDS

TRUST DSCP

trust dscp
Overview This command enables the premark-dscp map to replace the bandwidth-class,
CoS, DSCP, and queue of classified traffic based on a lookup DSCP value.
With the no variant of this command, no premark-dscp mapping function will be
applied for the selected class-map.QoS components of the packet existing either
at ingress, or applied by the class-map, will pass unchanged.
trust dscp
Syntax
no trust
Mode Policy-Map Configuration. Because policy-maps are applied to ports, you can think
of trust dscp as a per-port setting.
Examples To enable the premark-dscp map lookup for policy-map pmap1, use the
commands:
awplus#
awplus(config)#
awplus(config-pmap)#
To disable the premark-dscp map lookup for policy-map pmap1, use the
commands:
awplus#
awplus(config)#
awplus(config-pmap)#
Related mls qos map premark-dscp to
Commands
C613-50170-01 Rev B
configure terminal
policy-map pmap1
trust dscp
configure terminal
policy-map pmap1
no trust
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
1671