Auth Timeout Quiet-Period - Allied Telesis x510-28GTX Command Reference Manual

A C
UTHENTICATION OMMANDS
-
AUTH TIMEOUT QUIET PERIOD

auth timeout quiet-period

Overview This command sets a time period for which another authentication request is not
accepted on a given interface, after an authentication request has failed.
Use the no variant of this command to reset the quiet period to the default.
Syntax auth timeout quiet-period <1-65535>
no auth timeout quiet-period
Default The quiet period for port authentication is 60 seconds.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Examples To set the quiet period to 10 seconds for interface port1.0.2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
To reset the quiet period to the default (60 seconds) for interface port1.0.2, use the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the quiet period to 10 seconds for authentication profile 'student', use the
commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
To reset the quiet period to the default (60 seconds) for authentication profile
'student', use the commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
Related auth profile (Global Configuration)
Commands
C613-50170-01 Rev B
Parameter Description
<1-65535>
Specifies the quiet period (in seconds).
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
configure terminal
auth profile student
configure terminal
auth profile student
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
auth timeout quiet-period 10
no auth timeout quiet-period
auth timeout quiet-period 10
no auth timeout quiet-period
1749