Ip Pim Crp-Cisco-Prefix - Allied Telesis x510-28GTX Command Reference Manual

PIM-SM C
OMMANDS
- -
IP PIM CRP CISCO PREFIX

ip pim crp-cisco-prefix

Overview Use this command to interoperate with Cisco devices that conform to an earlier
draft standard. Some Cisco devices might not accept candidate RPs with a group
prefix number of zero. Note that the latest BSR specification prohibits sending RP
advertisements with prefix 0. RP advertisements for the default IPv4 multicast
group range 224/4 are sent with a prefix of 1.
Use the no variant of this command to revert to the default settings.
ip pim crp-cisco-prefix
Syntax
no ip pim crp-cisco-prefix
Mode Global Configuration
Usage Cisco's BSR code does not conform to the latest BSR draft. It does not accept
candidate RPs with a group prefix number of zero. To make the candidate RP work
with a Cisco BSR, use the ip pim crp-cisco-prefix command when interoperating
with older versions of Cisco IOS.
Example awplus#
awplus(config)#
awplus#
awplus(config)#
Related ip pim rp-candidate
Commands
C613-50170-01 Rev B
configure terminal
ip pim crp-cisco-prefix
configure terminal
no ip pim crp-cisco-prefix
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
1333