Dot1X Eapol-Version - Allied Telesis x510-28GTX Command Reference Manual

802.1X C
OMMANDS
1 -
DOT X EAPOL VERSION

dot1x eapol-version

Overview This command sets the EAPOL protocol version for EAP packets when 802.1X port
authentication is applied.
Use the no variant of this command to set the EAPOL protocol version to 1.
The default EAPOL protocol version is version 1.
dot1x eapol-version {1|2}
Syntax
no dot1x eapol-version
Default The EAP version for 802.1X authentication is set to 1 by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
To set the EAPOL protocol version to 2 for port1.0.2, use the commands:
Examples
awplus#
awplus(config)#
awplus(config-if)#
To set the EAPOL protocol version to the default version (1) for interface
port1.0.2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the EAPOL protocol version to 2 for authentication profile 'student', use the
commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
To set the EAPOL protocol version to the default version (1) for authentication
profile 'student', use the commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
C613-50170-01 Rev B
Parameter
1
2
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
configure terminal
auth profile student
configure terminal
auth profile student
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
EAPOL version.
EAPOL version.
dot1x eapol-version 2
no dot1x eapol-version
dot1x eapol-version 2
no dot1x eapol-version
1683