Show Dot1X Diagnostics - Allied Telesis x510-28GTX Command Reference Manual

802.1X C
OMMANDS
1
SHOW DOT X DIAGNOSTICS

show dot1x diagnostics

Overview This command shows 802.1X authentication diagnostics for the specified interface
(optional), which may be a static channel (or static aggregator) or a dynamic (or
LACP) channel group or a switch port.
If no interface is specified then authentication diagnostics are shown for all
interfaces.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
show dot1x diagnostics [interface <interface-list>]
Syntax
Mode Privileged Exec
Example See the sample output below showing 802.1X authentication diagnostics for
port1.0.5:
awplus#
C613-50170-01 Rev B
Parameter
interface
<interface-list>
show dot1x diagnostics interface port1.0.5
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Specify a port to show.
The interfaces or ports to configure. An interface-list can be:
• an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or
sa1-2, or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.2-1.0.4. Do not mix interface
types in a list
The specified interfaces must exist.
"Getting Started
Guide.
1700