Authorization Commands - Allied Telesis x510-28GTX Command Reference Manual

TACACS+ C
OMMANDS

AUTHORIZATION COMMANDS

authorization commands
Overview This command applies a command authorization method list, defined using the
aaa authorization commands
Use the no variant of this command to reset the command authorization
configuration on the console and VTY lines.
Syntax authorization commands <privilege-level> {default|<list-name>}
no authorization commands <privilege-level>
Default The default method list is applied to each console and VTY line by default.
Mode Line Configuration
Usage If the specified method list does not exist users will not be enable to execute any
commands in the specified method list on the specified VTY lines.
Example To apply the TAC15 command authorization method list with privilege level 15 to
VTY lines 0 to 5, use the following commands:
awplus#
awplus(config)#
awplus(config-line)#
To reset the command authorization configuration with privilege level 15 on VTY
lines 0 to 5, use the following commands:
awplus#
awplus(config)#
awplus(config-line)#
Related aaa authorization commands
Commands
C613-50170-01 Rev B
Parameter
<privilege-level>
default
<list-name>
configure terminal
line vty 0 5
configure terminal
line vty 0 5
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
command, to console and VTY lines.
Description
The privilege level of the set of commands the method list
will be applied to.
AlliedWare Plus defines three sets of commands, that are
indexed by a level value:
Level = 1: All commands that can be accessed by a user with
privilege level between 1 and 6 inclusive
Level = 7: All commands that can be accessed by a user with
privilege level between 7 and 14 inclusive
Level = 15: All commands that can be accessed by a user
with privilege level 15
Configure the default authorization commands method list.
Configure a named authorization commands method list
authorization commands 15 TAC15
no authorization commands 15
1977