Openflow Native Vlan - Allied Telesis x510-28GTX Command Reference Manual

O F C
PEN LOW OMMANDS

OPENFLOW NATIVE VLAN

openflow native vlan
Overview Use this command to specify a VLAN as a native VLAN for the data plane ports. You
must create a VLAN (using the
VLAN as a native VLAN.
The OpenFlow native VLAN must be different from the native VLAN of the control
plane. This prevents the OpenFlow ports from receiving any broadcast or multicast
traffic flooded on the control plane native VLAN.
The VLAN used as the OpenFlow native VLAN should not be used on
non-OpenFlow ports.
Use the no variant of this command to change the native VLAN for the data plane
ports back to the default VLAN 1.
openflow native vlan <vlan-id>
Syntax
no openflow native vlan
Default The native VLAN for the data plane ports is VLAN 1 by default.
Mode Global Configuration
Example To specify VLAN 100 as a native VLAN for the data plane ports:
awplus#
awplus(config)#
To change the native VLAN for the data plane ports back to the VLAN 1:
awplus#
awplus(config)#
Related show openflow config
Commands
C613-50170-01 Rev B
Parameter Description
<vlan-id>
VLAN ID in the range <1-4090>
configure terminal
openflow native vlan 100
configure terminal
no openflow native vlan
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
vlan database command) before specifying the
2045