Debug Nsm Mcast - Allied Telesis x510-28GTX Command Reference Manual

M C
ULTICAST OMMANDS

DEBUG NSM MCAST

debug nsm mcast
Overview Use this command to debug IPv4 events in the Multicast Routing Information Base
(MRIB).
This command is intended for use by Allied Telesis authorized service personnel
for diagnostic purposes.
Syntax debug nsm mcast
{all|fib-msg|mrt|mtrace|mtrace-detail|register|stats|vif}
Mode Privileged Exec and Global Configuration
Examples To enable debugging of all multicast route events, use the commands:
awplus#
awplus(config)#
To enable debugging of PIM register entries, use the commands:
awplus#
awplus(config)#
C613-50170-01 Rev B
Parameter Description
all
All IPv4 multicast debugging.
fib-msg
Forwarding Information Base (FIB) messages.
mrt
Multicast routes.
mtrace
Multicast traceroute.
mtrace-detail
Multicast traceroute detailed debugging.
register
Multicast PIM register messages.
stats
Multicast statistics.
vif
Multicast interface.
configure terminal
debug nsm mcast all
configure terminal
debug nsm mcast register
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
1291