Ipv6 Access-List Extended Proto - Allied Telesis x510-28GTX Command Reference Manual

IP 6 S A C
V OFTWARE CCESS ONTROL
6 -
IPV ACCESS LIST EXTENDED PROTO

ipv6 access-list extended proto

Overview Use this command when configuring an IPv6 extended access-list for filtering
frames that permit or deny packets with a specific value based on the IP protocol
number specified.
The no variant of this command removes a specified IPv6 extended access-list with
an IP protocol number.
ipv6 access-list extended <list-name> {deny|permit} proto
Syntax
<ip-protocol>} {<ipv6-source-address/prefix>|any}
{<ipv6-destination-address/prefix>|any} [log]
no ipv6 access-list extended <list-name> {deny|permit} proto
<ip-protocol>{<ipv6-source-address/prefix>|any}
{<ipv6-destination-address/prefix>|any} [log]
Table 39-2: IP protocol number and description
C613-50170-01 Rev B
L (ACL) C
IST OMMANDS
Parameter Description
<list-name>
A user-defined name for the IPv6 software extended access- list.
deny
Specifies the packets to reject.
permit
Specifies the packets to accept.
proto
The IP Protocol type specified by its protocol number in the
range 1 to 255.
<ip-protocol>
The IP protocol number, as defined by IANA (Internet Assigned
Numbers Authority
www.iana.org/assignments/protocol-numbers)
See below for a list of IP protocol numbers and their
descriptions.
<ipv6-source-
IPv6 source address, or local address.
address/prefix>
The IPv6 address uses the format X:X::X:X/Prefix-Length. The
prefix-length is usually set between 0 and 64.
any
Any source address or local address.
<ipv6-
IPv6 destination address, or local address.
destination-
The IPv6 address uses the format X:X::X:X/Prefix-Length. The
address/prefix>
prefix-length is usually set between 0 and 64.
any
Any destination address or remote address.
log
Log the results.
Protocol Number
1
2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Protocol Description [RFC]
Internet Control Message [RFC792]
Internet Group Management [RFC1112]
1593