Ipv6 Pim Register-Rate-Limit - Allied Telesis x510-28GTX Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 - -
IPV PIM REGISTER RATE LIMIT

ipv6 pim register-rate-limit

Overview Use this command to configure the rate of register packets sent by this DR, in units
of packets per second. The configured rate is per (S, G) state, and is not a system
wide rate.
Use the no variant of this command to remove the limit and reset to the default
rate limit.
ipv6 pim register-rate-limit <1-65535>
Syntax
no ipv6 pim register-rate-limit
Mode Global Configuration
Default The default is 0, as reset with the no variant, which also specifies an unlimited rate
limit.
Examples awplus#
awplus(config)#
awplus(config)#
awplus(config)#
awplus#
awplus(config)#
C613-50170-01 Rev B
Parameter Description
<1-65535>
Specifies the maximum number of packets that can be sent per second.
configure terminal
ipv6 forwarding
ipv6 multicast-routing
ipv6 pim register-rate-limit 3444
configure terminal
no ipv6 pim register-rate-limit 3444
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
1397