Ipv6 Pim Sparse-Mode - Allied Telesis x510-28GTX Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM SPARSE MODE

ipv6 pim sparse-mode

Overview Use this command to enable PIM-SMv6 on a VLAN interface.
Use the no variant of this command to disable PIM-SMv6 on a VLAN interface.
Syntax ipv6 pim sparse-mode
no ipv6 pim sparse-mode
Mode Interface Configuration for a VLAN interface.
awplus#
Examples
awplus(config)#
awplus(config)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus#
awplus(config)#
awplus(config-if)#
C613-50170-01 Rev B
configure terminal
ipv6 forwarding
ipv6 multicast-routing
interface vlan2
ipv6 enable
ipv6 pim sparse-mode
configure terminal
interface vlan2
no ipv6 pim sparse-mode
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
1407