Dot1X Authentication - Allied Telesis x510-28GTX Command Reference Manual

802.1X C
OMMANDS
1
DOT X AUTHENTICATION

dot1x authentication

Overview This command overrides the default 802.1X-based authentication method on an
interface by allowing you to apply a user-defined named list.
Use the no variant of this command to remove the named list from the interface
and apply the default method.
Syntax dot1x authentication {default|<list-name>}
no dot1x authentication
Default The default method list is applied to an interface by default.
Mode Interface Mode
To apply the named list 'vlan10_auth' on the vlan10 interface, use the
Example
commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove the named list from the vlan10 interface and set the authentication
method back to default, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related aaa authentication dot1x
Commands
C613-50170-01 Rev B
Parameter Description
default
Apply the default authentication method list
<list-name>
Apply the user-defined named list
configure terminal
interface vlan10
configure terminal
interface vlan10
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
dot1x authentication vlan10_auth
no dot1x authentication
1678