Ip Pim Hello-Holdtime (Pim-Sm) - Allied Telesis x510-28GTX Command Reference Manual

PIM-SM C
OMMANDS
- (PIM-SM)
IP PIM HELLO HOLDTIME

ip pim hello-holdtime (PIM-SM)

Overview This command configures a hello-holdtime value. You cannot configure a
hello-holdtime value that is less than the current hello-interval.
Use the no variant of this command to return it to its default of 3.5 * the current
hello-interval.
Syntax ip pim hello-holdtime <holdtime>
no ip pim hello-holdtime
Default The default hello-holdtime value is 3.5 * the current hello-interval. The default
hello- holdtime is restored using the negated form of this command.
Mode Interface Configuration for a VLAN interface.
Usage Each time the hello interval is updated, the hello holdtime is also updated,
according to the following rules:
If the hello holdtime is not configured; or if the hello holdtime is configured and
less than the current hello-interval value, it is modified to the (3.5 * hello interval).
Otherwise, it retains the configured value.
Example awplus#
awplus(config)#
awplus(config-if)#
C613-50170-01 Rev B
Parameter Description
<holdtime>
<1-65535>
The holdtime value in seconds (no fractional seconds are accepted).
configure terminal
interface vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ip pim hello-holdtime 123
1337