Table of Contents
Advertisement
54
Introduction
Overview
This chapter provides an alphabetical reference for Allied Telesis Management
Framework™ (AMF) commands.
AMF master
Every AMF network must have at least one master node, which acts as the core of
nodes
the AMF network. Not all AlliedWare Plus devices are capable of acting as an AMF
master. See the
about AMF master support.
AMF edge
CentreCOM® FS980M, GS900MX, GS970M, and XS900MX Series switches can only
be used as edge switches in an AMF network. The full management power and
convenience of AMF is available on these switches, but they can only link to one
other AMF node. They cannot form cross-links or virtual links.
AMF naming
When AMF is enabled on a device, it will automatically be assigned a host name. If
convention
a host name has already been assigned, by using the command
249, this will remain. If however, no host name has been assigned, then the name
applied will be the prefix, host_ followed (without a space) by the MAC address of
the device. For example, a device whose MAC address is 0016.76b1.7a5e will have
the name host_0016_76b1_7a5e assigned to it.
To efficiently manage your network using AMF, we strongly advise that you devise
a naming convention for your network devices, and accordingly apply an
appropriate hostname to each device in your AMF network.
AMF and STP
On AR-Series firewalls, you cannot use STP at the same time as AMF.
Command List
•
•
•
•
•
C613-50170-01 Rev B
Framework™ (AMF)
AMF Feature Overview and Configuration Guide
"area-link" on page 2223
"atmf
area" on page 2225
"atmf area
password" on page 2227
"atmf
authorize" on page 2229
"atmf authorize
provision" on page 2231
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Allied Telesis
Management
Commands
for information
hostname
on page
2218
Hide quick links:
Advertisement
Chapters
Table of Contents
