Multicast Commands; Introduction; Chapter 32: Multicast Commands - Allied Telesis x510-28GTX Command Reference Manual

32

Introduction

Overview This chapter provides an alphabetical reference of multicast commands for
configuring:
•
•
•
For commands for other multicast protocols, see:
•
•
•
•
•
NOTE
the
with the
with the
Static IPv6 multicast routes take priority over dynamic IPv6 multicast routes. Use the
clear ipv6 mroute
IPv6 multicast routes can take over from previous static IPv6 multicast routes.
The IPv6 Multicast addresses shown can be derived from IPv6 unicast prefixes as per
RFC 3306. The IPv6 unicast prefix reserved for documentation is 2001:0db8::/32 as per
RFC 3849. Using the base /32 prefix the IPv6 multicast prefix for 2001:0db8::/32 is
ff3x:20:2001:0db8::/64. Where an RP address is 2001:0db8::1 the embedded RP
multicast prefix is ff7x:120:2001:0db8::/96. For ASM (Any-Source Multicast) the IPV6
multicast addresses allocated for documentation purposes are ff0x::0db8:0:0/96 as per
RFC 6676. This is a /96 prefix so that it can be used with group IDs as per RFC 3307. These
addresses should not be used for practical networks (other than for testing purposes),
nor should they appear in any public network.
C613-50170-01 Rev B
IPv4 and IPv6 multicast forwarding
IPv4 and IPv6 static multicast routes
mroutes (routes back to a multicast source)
IGMP and IGMP Snooping Commands
MLD and MLD Snooping Commands
PIM-SM Commands
PIM-SMv6 Commands
PIM-DM Commands
: Before using PIM-SMv6 commands, IPv6 must be enabled on an interface with
ipv6 enable command, IPv6 forwarding must be enabled globally for routing IPv6
ipv6 forwarding command, and IPv6 multicasting must be enabled globally
ipv6 multicast-routing
command to clear static IPv6 multicast routes and ensure dynamic
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Multicast
Commands
command.
1284