Ip Pim Dense-Mode - Allied Telesis x510-28GTX Command Reference Manual

PIM-DM C
OMMANDS
-
IP PIM DENSE MODE

ip pim dense-mode

Overview This command enables or disables PIM-DM operation from Interface mode on the
current VLAN interface. This command also disables passive mode on the VLAN
interface if passive mode has been enabled using an
command.
The no variant of this command disables all PIM-DM activities on the interface.
ip pim dense-mode
Syntax
no ip pim dense-mode
Mode Interface Configuration for a VLAN interface.
awplus#
Example
awplus(config)#
awplus(config-if)#
C613-50170-01 Rev B
configure terminal
interface vlan2
ip pim dense-mode
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ip pim dense-mode passive
1444