Auth Timeout Reauth-Period - Allied Telesis x510-28GTX Command Reference Manual

A C
UTHENTICATION OMMANDS
-
AUTH TIMEOUT REAUTH PERIOD

auth timeout reauth-period

Overview This command sets the timer for reauthentication on a given interface. The
re-authentication for the supplicant (client device) is executed at this timeout. The
timeout is only applied if the auth reauthentication command is applied.
Use the no variant of this command to reset the reauth-period parameter to the
default (3600 seconds).
auth timeout reauth-period <1-4294967295>
Syntax
no auth timeout reauth-period
Default The default reauthentication period for port authentication is 3600 seconds, when
reauthentication is enabled on the port.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
To set the reauthentication period to 1 day for interface port1.0.2, use the
Examples
following commands:
awplus#
awplus(config)#
awplus(config-if)#
To reset the reauthentication period to the default (3600 seconds) for interface
port1.0.2, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the reauthentication period to 1 day for authentication profile 'student', use
the commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
To reset the reauthentication period to the default (3600 seconds) for
authentication profile 'student', use the commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
C613-50170-01 Rev B
Parameter Description
<1-4294967295>
The reauthentication timeout period (in seconds).
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
configure terminal
auth profile student
configure terminal
auth profile student
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
auth timeout reauth-period 86400
no auth timeout reauth-period
auth timeout reauth-period 86400
no auth timeout reauth-period
1750