Ipv6 Pim Bsr-Candidate - Allied Telesis x510-28GTX Command Reference Manual

PIM-SM 6 C
V OMMANDS
6 -
IPV PIM BSR CANDIDATE

ipv6 pim bsr-candidate

Overview Use this command to give the device the candidate BSR (Bootstrap Router) status
using the specified IPv6 address mask of the interface.
Use the no variant of this command to withdraw the address of the interface from
being offered as a BSR candidate.
Syntax ipv6 pim bsr-candidate <interface> [<hash>] [<priority>]
no ipv6 pim bsr-candidate [<interface>]
Mode Global Configuration
Default The default hash parameter value is 126 and the default priority parameter value is
64.
Examples To set the BSR candidate to the VLAN interface vlan2, with the optional mask
length and BSR priority parameters, enter the commands shown below:
awplus#
awplus(config)#
awplus(config)#
awplus(config)#
To withdraw the address of vlan2 from being offered as a BSR candidate, enter:
awplus#
awplus(config)#
C613-50170-01 Rev B
Parameter Description
<interface> Specify the interface. For instance, VLAN interface vlan2.
<hash>
<0-128> configure the hash mask length used for RP selection. The
default hash value if you do not configure this parameter is 126.
<priority>
<0-255> configure priority for a BSR candidate. Note that you must
also specify the <hash> (mask length) when specifying the <priority>.
The default priority if you do not configure this parameter is 64.
configure terminal
ipv6 forwarding
ipv6 multicast-routing
ipv6 pim bsr-candidate vlan2 20 30
configure terminal
no ipv6 pim bsr-candidate vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
1385