Example For Configuring Layer 2 Topology Detection; Figure 7-4 Networking Diagram For Configuring Layer 2 Topology Detection - Huawei Quidway S9300 Configuration Manual

7 ARP Configuration

7.9.4 Example for Configuring Layer 2 Topology Detection

Networking Requirements
As shown in
addresses of the two GE interfaces are shown in the figure.

Figure 7-4 Networking diagram for configuring Layer 2 topology detection

Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Create VLAN 100 and add the two GE interfaces of the S9300 to VLAN 100 in default mode.
# Create VLANIF 100 and assign an IP addresses to VLANIF 100.
<Quidway> system-view
[Quidway] vlan 100
[Quidway-vlan100] quit
[Quidway] interface vlanif 100
[Quidway-vlanif100] ip address 10.1.1.2 24
[Quidway-vlanif100] quit
# Add the two GE interfaces to VLAN 100 in default mode.
[Quidway] interface gigabitethernet 1/0/1
[Quidway-GigabitEthernet1/0/1] port link-type access
[Quidway-GigabitEthernet1/0/1] port default vlan 100
7-24
Figure 7-4, two GE interfaces are added to VLAN 100 in default mode and the IP
PC A
10.1.1.1/24
Add two GE interfaces to VLAN 100 in default mode.
Enable Layer 2 topology detection and view changes of ARP entries.
Types and numbers of the interfaces to be added to a VLAN
IP addresses of the VLANIF interface and the PCs
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
S9300
VLANIF100
10.1.1.2/24
PC B
VLAN100
10.1.1.3/24
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)