Connection To Smash-Clp - Hitachi Compute Blade 2000 User Manual

SMASH can perform many types of operations defined by CIM (Common
Information Model) profiles. X57A2, X55R3, and X55S3, and X55R4 server blade
models support CIM profiles shown in the table below. See DMTF Web site for
details about CIM profiles.
http://dmtf.org/standards/profiles
CIPM profiles
# DSP
1 DSP1004
2 DSP1006
3 DSP1007
4 DSP1009
5 DSP1011
6 DSP1012
7 DSP1013
8 DSP1015
9 DSP1018
10 DSP1022
11 DSP1026
12 DSP1033
13 DSP1034

Connection to SMASH-CLP

SMASH-CLP (Command Line Protocol) is available using terminal software on a
console terminal connected via Telnet or SSH. Steps for connection are as follows.
1 Start the terminal software on a console terminal, and connect to a server blade,
on which you use SMASH-CLP, via Telnet or SSH. See Chapter 6 > LC
Command > P: partition network setting for the server blade IP address.
2 Type a user name and password in connection via Telnet or SSH to connect to
SMASH-CLP. See Chapter 5 > Initial Settings with Server Blade Web Console >
User Account Configuration for how to set a user name and password.
CIM profile
Base Server
SMASH Collection
SM CLP Admin Domain
Sensors
Physical Asset
Boot Control
Fan
Power Supply
Service Processor
CPU
System Memory
Profile Registration
Simple Identity Management
1791
Organization Version
DMTF 1.0.0 or later
DMTF 1.0.0 or later
DMTF 1.0.0 or later
DMTF 1.0.0 or later
DMTF 1.0.0 or later
DMTF 1.0.0 or later
DMTF 1.0.0 or later
DMTF 1.0.0 or later
DMTF 1.0.0 or later
DMTF 1.0.0 or later
DMTF 1.0.0 or later
DMTF 1.0.0 or later
DMTF 1.0.0 or later