Dumb Terminal Service Configuration Commands; Auto-Execute Command - 3Com 3C13618 Command Reference Manual

Parameter
None
Description
Using the send switch command, you can enable/disable a terminal to receive
messages from other terminals.
By default, a terminal is enabled to receive the messages from other terminals.
In terminal message service, whether to receive messages from other terminals is
decided by the send switch command. If the terminal message service is currently
enabled, it will be disabled after a second input of this command.
For related commands, see send status.
Example
# Display the status of the terminal for receiving messages from other terminals (the
terminal was enabled to receive the messages).
[3Com] send switch

2.3 Dumb Terminal Service Configuration Commands

2.3.1 auto-execute command

Syntax
auto-execute command command
undo auto-execute command command
View
Asynchronous serial interface view
Parameter
command: An entire command line.
Description
Using the auto-execute command command, you can configure the command to be
executed automatically on the asynchronous serial interface. Using the undo
System Management
25