Idle-Mark - 3Com 3C13618 Command Reference Manual

keepalive-interval: Define keepalive timeout, ranging from 1 to 60000 seconds. By
default, keepalive-interval is 30 seconds.
local-pending seconds: Time to wait for local pending, ranging from 1 to 60000
seconds. By default, local-pending seconds is 10 seconds.
remote-pending seconds: Time to wait for the remote peer pending, ranging from 1
to 60000 seconds. By default, remote-pending seconds is 30 seconds.
Description
Using the dlsw timer command, you can configure the parameters of DLSw timer.
Using the undo dlsw timer command, you can restore the default parameters.
The value of various timer used when DLSw established virtual circuits can be
modified by configuring the DLSw protocol timer. It is recommended that subscribers
do not modify or configure the parameters of DLSw timers under normal.
Example
None

6.1.14 idle-mark

Syntax
idle-mark
undo idle-mark
View
Synchronous interface view
Parameter
None
Description
Using the idle-mark command, you can assign the encoding mode for the idle time
of synchronous interface. Using the undo idle-mark command, you can restore the
default encoding mode for the idle time of synchronous interface.
By default, the synchronous interface adopts "7E" encoding mode
The SDLC serial ports encapsulated by Quidway series of routers is identified with
"7E" during the idle time, but all of the serial ports on some SDLC equipment use high
Network Protocol
107