Dialer Enable-Circular - 3Com 3C13618 Command Reference Manual

Description
Using the dialer circular-group command, you can configure adding the specified
physical interface to a dialer rotary group. Using the undo dialer circular-group
command, you can cancel the configuration.
By default, the physical interface is not a member of any dialer circular group.
One physical interface can only be assigned to a dialer circular group, which may
contain multiple physical interfaces. When a call is originated on a dialer interface, the
hightest priority physical interfaces in the circular group on the dialer interface will
place the call.
For related commands, see interface dialer.
Example
# Assign Serial1 and Serial2 to dialer circular group1.
[3Com-Serial1] dialer circular-group 1
[3Com-Serial2] dialer circular-group 1

1.1.8 dialer enable-circular

Syntax
dialer enable-circular
undo dialer enable-circular
View
Physical or dialer interface view
Parameter
None
Description
Using the dialer enable-circular command, you can enable Circular DCC. Using the
undo dialer enable-circular command, you can disable Circular DCC.
By default, Circular DCC is enabled on the ISDN interfaces and disabled on other
interfaces.
The user must use this command to enable it before using Circular DCC.
For related commands, see dialer circular-group.
Dial-Up
9