Fr Dlci-Switch - 3Com 3C13618 Command Reference Manual

must use this command to configure the PVC number at both the DCE side and the
DTE side.
After configuring this command, you will enter the DLCI view in which you can configure
the associated class for the PVC.
For related commands, see link-protocol fr.
Example
# Assign PVC number 200 to the Frame Relay interface Serial 0.
[3Com-Serial0]fr dlci 200
[3Com-fr-dlci-200]

6.1.28 fr dlci-switch

Syntax
fr dlci-switch in-dlci interface type number dlci out-dlci
undo fr dlci-switch in-dlci
View
Interface view
Parameter
in-dlci: The DLCI number on the interface.
interface type number: interface number of packet forwarded by a router.
out-dlci: DLCI on which the packet is forwarded on the specified interface.
Description
Using the fr dlci-switch command, you can configure the static route for Frame Relay
PVC switching. Using the undo fr dlci-switch command, you can cancel a static route.
Before the static route of Frame Relay PVC is configured, it is necessary to enable the
Frame Relay PVC switching first by using the command fr switching.
For related commands, see fr switching.
Example
# Configure a static route that allows packets in DLCI 100 on Seiral1 and transmits
packets out over DLCI 200 on interface Serial2.
[3Com-Serial1]fr dlci-switch 100 interface serial 2 dlci 200
Link Layer Protocol
113