Rip Work - 3Com 3C13618 Command Reference Manual

View
Interface view
Parameter
1: RIP Version 1.
2: RIP Version 2.
multicast: Supports RIP-2 broadcast packet.
multicast: Supports RIP-2 multicast packet.
Description
Using the rip version command, you can configure the RIP version working on an
interface. Using the undo rip version command, you can restore the default version
working on an interface.
RIP-1 is the default version used on the interface. When RIP-2 is used on the
interface, multicast is the default mode.
RIP-2 has 2 transmission modes: broadcast and multicast. Multicast is the default
mode. The multicast address in RIP-2 is 224.0.0.9. One of the advantages of
multicast mode is that the hosts that do not run RIP in this network will not receive the
broadcast packets. Additionally, hosts running RIP-1 will be prevented from receiving
and processing the RIP-2 routes with subnet masks.
When the interface specifies the use of RIP-1, only RIP-1 and RIP-2 broadcast
packets will be received. In this case, RIP-2 multicast packets will be rejected. When
the interface is specified to use RIP-2 multicast, only RIP-2 multicast packets and
RIP-2 broadcast packets will be received. In this case, RIP-1 packets will be rejected.
Example
# Set Serial 0 supports RIP-2 broadcast packets.
[3Com-Serial0] rip version 2 broadcast

2.1.23 rip work

Syntax
rip work
undo rip work
Routing Protocol
31