3Com 3C13618 Command Reference Manual page 835

undo dialer threshold
View
Dialer interface view
Parameter
traffic-percentage: Percentage of the actual traffic on the link over the bandwidth,
ranges from 0 to 99.
in-out: Calculates the larger one of the inbound traffic and the outbound traffic in the
actual traffic calculation.
in: Only the inbound traffic is calculated.
out: Only the outbound traffic is calculated.
Description
Using the dialer threshold command, you can configure the traffic threshold of a link
on the DCC interface so that another link can be enabled to call the same destination
address when the ratio of traffic on all connected links on the DCC interface to the
available bandwidth exceeds the preset percentage. Using the undo dialer
threshold command, you can restore the default value.
By default, traffic control is not enabled.
All the available links will be enabled to calls if traffic-percentage is set to 0.
If the ratio of the traffic on a link of a DCC interface to the bandwidth exceeds a
defined threshold, the second link will be enabled to implement MP binding with the
first one. When the ratio of traffic on the two links to the bandwidth exceeds a defined
threshold, the third link will be enabled, so on and so forth. On the contrary, when the
ratio of the traffic on N (N is an integer greater than or equal to 2) links to the
bandwidth of N-1 links is less than a defined threshold, a link will be disabled. In
Circular DCC, this command is used on the interfaces corresponding to the dialer
circular-group (including ISDN BRI/PRI interfaces and dialer interfaces). In
Resource-Shared DCC, this dialer threshold command is applied to dialer interface
only. In addition, this command must be used together with the ppp mp command.
For related commands, see ppp mp.
Example
# Set the traffic threshold on Dialer1 to 80%.
[3Com-Dialer1] dialer threshold 80
Dial-Up
15