Reset Ipsec Sa - 3Com 3C13618 Command Reference Manual

3Com Command Reference Guide — V1.00
Parameter
slot-id: The ID of the slot where the crypto card is located. The value range is
determined by the number of slots on the router. All crypto cards will be operated if
this value is not input.
Description
Using the reset encrypt-card syslog command, you can cancel all the log
information in the crypto cards.
This command is applicable to crypto cards.
The history log information is reserved at the crypto card side and is incremented
eventually. Whenever queried, the crypto card log will report all the information
(including the outdated information). It incurs the difficulties on monitoring and
locating problems. In this case, you can use the reset encrypt-card syslog
command to reset the information stored in the log buffer at the crypto card side in
time.
For related commands, see encrypt-card set syslog, display encrypt-card syslog.
Example
# Cancel all the log information on the crypto card in Slot 0.
[3Com] reset encrypt-card syslog 0

4.1.36 reset ipsec sa

Syntax
reset ipsec sa { all | remote ip-address | policy policy-name [ sequence-numberber ]
| parameters dest-address protocol spi }
View
All views
Parameter
all: Deleting all the SAs.
remote: Deleting an SA whose remote address is ip-address.
ip-address: Specifying remote address, in the IP address format: A.B.C.D.
policy: Deleting the SA in a security policy group whose name is policy-name, with
the serial number of security policy being sequence-number..
78