E1-F Interface Configuration Commands; Display Fe1 Serial - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
a D channel, timeslot 24 will be automatically bound). The logic feature of this pri-set
will be the same like that of an ISDN PRI interface. If timeslots to be bound are not
specified, all the timeslots will be bound to form an ISDN PRI interface similar to
23B+D.
After the timeslot binding, the interface will automatically create a Serial interface
owing the same logic feature as that of an ISDN PRI interface. The number of the
Serial interface is serial number:23. number starts from the largest serial interface
number plus 1.
Only one timeslot binding mode can be supported on one /PRI interface at one time,
that is, this command and the channel-set command cannot be used at the same
time.
For related commands, see channel-set.
Example
# Bind the timeslots 1, 2, 8 to 12 of the /PRI interface as a pri-set.
[3Com-T1-0]pri-set timeslot-list 1,2,8-12

3.4 E1-F Interface Configuration Commands

3.4.1 display fe1 serial

Syntax
display fe1 [ serial serial-number ]
View
All views
Parameter
serial serial-number: Interface type and number. If no interface is specified, the
information of all the E1-F interfaces will be displayed.
Description
Using the display fe1 serial command, you can view the configuration and state of
E1-F interface.
If the specified interface is a serial interface rather than an E1-F interface, the system
will display the error prompt "The serial is not a factional interface".
48