Ipx Split-Horizon - 3Com 3C13618 Command Reference Manual

By default the preference of the static SAP entry is 10 and the preference of the
dynamic one is 60. The smaller the value, the higher the preference will be.
Generally, you can use the services announced by NetWare and saved the server.
Under certain conditions, you can specify the service for usage.
For related commands, see display ipx service-table.
Example
# Add a piece of service information of type 4 at 1000.0.0c91.f61f.
[Quidway] ipx service 4 server1 1000.0.0c91.f61f 451 2
# Add a piece of service information of type 4 at 1000.0.0c91.f61f and with a
preference of 40
[Quidway] ipx service 4 server1 1000.0.0c91.f61f 451 2 preference 40

5.1.24 ipx split-horizon

Syntax
ipx split-horizon
undo ipx split-horizon
View
Interface view
Parameter
None
Description
Using the ipx split-horizon command, you can enable split-horizon algorithm on this
interface. Using the undo ipx split-horizon command, you can disable the function.
By default, split-horizon is enabled.
The split-horizon arithmetic can prevent route loop. Split-horizon means that an
interface will not send out routes received. But in some unusual conditions,
split-horizon should be disabled to achieve the correct transmission by sacrificing
efficiency. It will be better not to use the configuration of disabling RIP split-horizon
without thinking. Disabling split-horizon will have no effect on point-to-point links.
Network Protocol
93